Cleaning Chemicals
Absolutely. Our chemicals are safe for machine use or manual use.
No. As we do not know what the chemical is, chances are it will damage the machine. Our detergent is professionally formulated and has built-in anti-foaming agents to protect our machines.
Normally we work on 60 square meters as a general rule. This is obviously dependant on the state of the carpets as well as the type of carpet. Some carpets are far more absorbent than others. These factors can either increase or decrease the area and will be up to the customer to judge.
The Carpet Cleaner, as a general rule, is enough to clean a house with 3 bedrooms and a dining room area.
Yes. All chemicals are produced to strict SABS standards and are ISO9002 approved. If ingestion occurs follow the recommendations on the back label of the chemical. Chemicals are not toxic or life-threatening.
Placing them in the machine will not damage the machine. However, it will dilute the chemicals. The chemicals and their dilutions were calibrated to be used straight onto the problem area thus ensuring that results are achieved without unnecessary time wastage.
Carpet Cleaner:
75ml mixed into the white bucket at the front of the machine or approximately 8 litres of warm water. To be used in conjunction with our machines or by hand. If used by hand they must put detergent on the affected area wait for it to dry then vacuum up.
High Traffic / Stain:
Both of these are pre spotters. Using a clean cloth or sponge soaked with the chemical then apply directly to the stain / high traffic area. Leave for approximately 5 minutes then go over the area with the machine to ensure all of the chemical is extracted. You should not leave the stain remover on the carpet for too long as it may remove the carpet’s colour.
Odour Eliminator:
After cleaning spray in the affected area and leave to work. The microbial enzyme agent attaches itself to the odour causing molecules and destroys the smell at its source. Can be used in fridges, for pet smells, shoes etc.
Upholstery Cleaner:
Used in the same way as Carpet Cleaner, 75ml into approximately 8 liters of water. If you want to use it by hand then apply the chemical to the affected area. Allow to dry, then vacuum up.
Hard Floor Cleaner:
75ml into approximately 3 litres of water. Concentration can be adjusted according to the customer’s requirements. Can be used with either the hard floor machine or with a mop.
Spray and Buff Polish:
Clean surface before use. Ensure the floor is dry. Spray polish onto the floor then buff with either the hard floor machine or with a mop or damp cloth.
Laminate Cleaner:
75ml into 3 litres of water. Concentration can be adjusted according to the customer’s requirements. Can be used with either the hard floor machine or with a mop.